Error When Posting – CLF Not Found
Read this article help fix the “CLF Not Found” error that pops up when trying to post out a program in the software.
What is a Post Processor?
This article will help you learn about Post Processors in general. It will describe what they are and what they are used for inside of BobCAD.
Building a 5 Axis Rotary Tilt
This article will help describe how a 5 axis Rotary Tilt machine is built inside of BobCAD for use in simulation.
Find Direction of Rotation & Rotary Type
This document defines the steps taken to determine the Rotary Axis Mode and the Direction of Rotation.
Pre-Installed Post Processors
If you are new to BobCAD or are looking for a post processor but can not one for your machine in the software or in the post processor database on the support site, this information is for you.
Request a Post Processor
If you are new to BobCAD or are looking for a post processor but can not one for your machine in the software or in the post processor database on the support site, this information is for you.