Getting Setup

This document is made to give new BobCAD users a basic understanding of how to set up a job, create toolpath and post out code for a Mill, Plasma, Laser or Waterjet machine.

This document is a walk-through on how to customize the User Interface for BobCAD.

Users are now able to transfer their license off of their computer by following the steps below.  Before being able to register the license on a new computer, the steps below will have to be completed.

If you are new to BobCAD or are looking for a post processor but can not one for your machine in the software or in the post processor database on the support site, this information is for you.

If you are new to BobCAD or are looking for a post processor but can not one for your machine in the software or in the post processor database on the support site, this information is for you.

You can setup your network license to run as a service on your computer. This will allow the computer to run the service automatically upon starting the computer and allow the network license to be active. 

The information in this article will tell you how to setup a network license in BobCAD.  

 This article will provide information on how to setup a standard license using the manual request option in the Registration wizard.

This article will provide information on how to register a demo license in BobCAD. 

This article will provide information about how to register a standard license of BobCAD using the internet.