Questions in BobCAD Version 22
Page 1 out of 6 Pages
- How do I draw a 2D thread in lathe mode? Example: 1" 8 TPI
(1756 views) - I downloaded "MillEditPost" from the Posts page and now I get a "MillingRegistryClassesR.dll" was not found error message. MillEditPost worked before but it had problems finding file paths so I thought I would reload it.
(2024 views) - How do we open a .CAT (catia) file?
(234 views) - How do I tap on Lathe in V22?
(263 views) - What causes the error when a rapid Z plane greater than .1 is use in the random center drill or drilling cycles? I need to set the Z rapid plane to clear part clamps, but will not run if the R value is greater than .1
(271 views) - We just purchased and recieved your software, with a two user license.
What I want to know is the book says you have minimum system requirements and recommended system requirements for installation- What is the difference, and is the software supposed to "live" on a server or on the individual computers?
(1169 views) - We just purchased and recieved your software, with a two user license.
What I want to know is the book says you have minimum system requirements and recommended system requirements for installation- What is the difference, and is the software supposed to "live" on a server or on the individual computers?
(871 views) - Does v22 allow you to center justify your text within a rectangle?
(642 views) - How do I transfer custom default settings from one workstation to another?
(605 views) - How to correct the Simulation if it is Not operational.
(819 views)