BobCAD Version 22

ID #1111

I downloaded "MillEditPost" from the Posts page and now I get a "MillingRegistryClassesR.dll" was not found error message. MillEditPost worked before but it had problems finding file paths so I thought I would reload it.

The .dll files required for that utility need to be in the same folder as the .exe file is. It doesn't actually matter where the utility is, just so that those .dlls and the .exe are in the same place. The simplest way to make sure they are is to copy the MillEditPost.exe file into BobCAD-CAM's installation folder. The main application uses many of the same dll files and they're found there.

 

Tags: -

Related entries:

Last update: 2009-01-28 09:14
Author: Glen
Revision: 1.0

Digg it! Print this record Send to a friend Show this as PDF file
Propose a translation for Propose a translation for
Please rate this entry:

Average rating: 2.5 out of 5 (2 Votes )

completely useless 1 2 3 4 5 most valuable

You cannot comment on this entry